Split Renal Function Test: What It Measures

Formulas & functions · Updated November 22, 2026

A split renal function test estimates how much each kidney contributes to the pair’s overall function. It is usually a nuclear medicine scan, also called a renogram or renal scintigraphy study; it can show whether one kidney is doing less work than the other, but it does not by itself explain why.

What split renal function means

Both kidneys normally filter blood and help regulate fluid, salts, and waste products. A split function result describes the relative contribution of the right and left kidneys, often as percentages that add up to 100. For example, a report might estimate that the right kidney contributes 42% and the left 58% of the measured function.

This is different from a blood test such as estimated glomerular filtration rate (eGFR). eGFR estimates the combined filtering function of both kidneys, while a split function scan compares their contributions. A result of 50% and 50% does not prove that total kidney function is normal: both kidneys could be impaired to a similar degree. Conversely, one kidney may contribute less while the total function remains adequate because the other kidney compensates.

The phrase can also refer to a measurement made as part of a renal nuclear scan rather than to one single, standardized test. The tracer, camera, timing, calculation method, and local reference range can differ. For that reason, the report should be interpreted with the symptoms, blood and urine tests, and structural imaging.

Why a clinician may request the test

The scan is useful when knowing each kidney’s contribution could affect diagnosis, monitoring, or treatment. It may be requested when ultrasound, CT, or another study shows a difference in kidney size, dilation, scarring, or possible blockage. It can help establish a baseline and help clinicians judge whether function changes over time.

  • Urinary obstruction: In a person with hydronephrosis or suspected narrowing where the kidney joins the ureter, a scan may assess function and, with an appropriate drainage study, how readily urine leaves the kidney.
  • Unequal kidney size or suspected damage: It can help estimate the contribution of a kidney affected by scarring, a congenital difference, or prior injury.
  • Planning treatment: Before some operations, including procedures that may remove or reconstruct part of the urinary tract, the team may want to know how much function each kidney provides.
  • Follow-up: A repeat study may be considered if the clinician needs to compare function after treatment or during observation.

A scan is not automatically needed for every kidney stone, urinary infection, or abnormal ultrasound. The question it is meant to answer matters: a test for relative function is not interchangeable with a test designed to show anatomy or urine drainage.

Types of renal scans and tracers

Different radiotracers answer related but not identical questions. A dynamic scan commonly uses technetium-99m MAG3 or DTPA. The tracer is injected into a vein, and a gamma camera records its passage from the blood into the kidneys and, over time, into the collecting systems and bladder. The images and tracer curves can be used to estimate relative function and assess drainage.

MAG3 is often selected when kidney function is reduced because it is efficiently taken up and excreted by the kidneys. DTPA is filtered by the glomeruli and may be used when filtration is of particular interest. A DMSA scan is different: it is generally used to image functioning kidney cortex and identify areas of cortical scarring, rather than to assess drainage during a dynamic renogram. The referring clinician and nuclear medicine department select the study based on the clinical question and local protocol.

A diuretic, commonly furosemide, may be given during some renograms. It increases urine production so the team can assess whether tracer clears from a collecting system after the kidneys are stimulated to drain. This is not required for every scan. The request and protocol determine whether the study includes this step.

How to prepare

Preparation is usually straightforward, but follow the imaging department’s instructions because protocols differ. Patients are commonly asked to drink fluids before the scan and to arrive with a reasonably full bladder. Some departments ask the patient to empty the bladder just before imaging or again during the study. Adequate hydration can help produce images that are easier to interpret.

  • Tell the department about pregnancy, possible pregnancy, or breastfeeding before the appointment.
  • Bring a list of medicines and mention recent imaging or procedures involving the urinary tract.
  • Ask whether to take usual medicines. Do not stop a prescribed medicine unless the clinical team instructs you to.
  • Follow any instructions about fasting or fluid intake; these are not the same for every scan.

Children may receive different preparation and imaging arrangements. If a patient has difficulty holding urine, has a urinary catheter, or cannot drink normally, notifying the team in advance can help them plan the examination.

What happens during the test

After check-in, a technologist may ask the patient to remove items that could interfere with imaging and explain the sequence. A small amount of radiotracer is injected into a vein, usually in the arm. The patient then lies still beneath or in front of a gamma camera while images are taken. The camera detects radiation from the tracer; it does not produce the radiation itself.

For a dynamic renogram, imaging often starts around the time of injection and continues for a period while the tracer moves through the kidneys. If a diuretic is part of the protocol, it may be given before or during imaging. The patient may be asked to urinate, and additional images may be taken afterward. The exact appointment and scan duration vary with the protocol and whether extra images are needed.

The scan is generally noninvasive apart from the IV injection. Lying still is important, since movement can blur images. Most people can resume usual activities afterward unless their care team gives different instructions. Drinking fluids and emptying the bladder after the scan may help clear the tracer; follow the department’s advice.

How results are reported

The report may include the estimated percentage contributed by each kidney, image findings, and observations about tracer uptake and drainage. A roughly even split is common in people with two functioning kidneys, but there is no single percentage cutoff that determines health or treatment for every person. Values near an even split are interpreted in light of the scanner method and the laboratory’s reference approach.

A difference can be clinically relevant, but it is not a diagnosis on its own. For instance, a 35% contribution from one side and 65% from the other indicates an imbalance in the measured relative contribution. The clinician will consider whether this fits the ultrasound or CT findings, the person’s overall eGFR, prior results, and the reason the scan was ordered. A small change between two scans may reflect technical or biological variation rather than a definite change in kidney health.

Drainage and relative function are related but separate parts of interpretation. Tracer may clear slowly because of obstruction, a large collecting system, hydration, bladder fullness, or other factors. A drainage curve should not be read in isolation, and a report may describe limitations if the study conditions made the result uncertain.

Limitations and common misunderstandings

A split function percentage is a relative measure, not a direct statement of how many milliliters each kidney filters per minute. If both kidneys have reduced function, their shares could still look balanced. Blood creatinine and eGFR, urine testing, and clinical assessment provide different information that may be needed to understand overall kidney health.

Results can also be affected by the tracer and calculation method, patient movement, hydration, bladder status, and the timing or dose of a diuretic. A nuclear scan provides functional information but usually does not show fine anatomical detail as clearly as ultrasound, CT, or MRI. In turn, an anatomical scan may show dilation or a narrowing without establishing how much function each kidney contributes.

Another common misconception is that a low relative percentage automatically means a kidney must be removed. Treatment decisions depend on symptoms, the cause of reduced function, infection or obstruction risk, the function of the other kidney, and whether treatment can preserve or improve drainage. The scan informs a decision; it does not make the decision by itself.

Safety and radiation

Renal scintigraphy uses a small amount of radioactive tracer. The radiation exposure is generally low, but the appropriate test depends on the person and the clinical need. The radiotracer is different from the iodinated contrast material used for many CT scans. The department can explain the specific tracer, expected exposure, and any precautions for that protocol.

Pregnancy or possible pregnancy should be discussed before the test so the clinician can weigh the benefit against potential risk and consider whether another approach is suitable. Breastfeeding instructions depend on the radiopharmaceutical and local guidance; do not assume that feeding must stop or can continue without a pause. Ask the nuclear medicine team for agent-specific advice. Allergic reactions to radiotracers are uncommon, but report a prior reaction or relevant medical concern before the injection.

Alternatives and complementary tests

The best alternative depends on what needs to be known. Ultrasound can assess kidney size, collecting-system dilation, and some structural abnormalities without ionizing radiation. CT or MRI may provide more detailed anatomy in selected cases. Blood tests, urine tests, and eGFR help assess overall kidney function but do not usually separate the right kidney’s contribution from the left.

Other nuclear medicine studies may answer a different functional question. A DMSA scan can assess cortical defects, while a diuretic renogram may be chosen to examine drainage as well as relative function. These tests are not substitutes in every situation. The clinician should explain what question the proposed examination is intended to settle and whether its result is likely to change management.

Cost and access

There is no single price for a split renal function test. Cost depends on country, facility, tracer and protocol, whether a diuretic study is included, and insurance or public-health coverage. The appointment may involve separate charges for imaging, radiopharmaceuticals, and professional interpretation. Before scheduling, patients can ask the imaging center or insurer for an estimate and confirm whether prior authorization or a referral is required. The referring clinician can also clarify whether a less costly or more available test would answer the same clinical question.

Frequently Asked Questions

Is a split renal function test painful?
The scan itself is not usually painful. The IV insertion may briefly sting, and lying still for imaging can be uncomfortable for some people. If a diuretic is used, it can increase the urge to urinate.

Does a 50/50 result mean both kidneys are healthy?
No. It means their measured contributions are similar, not that total kidney function is normal. Overall function is assessed using other information, including blood tests, urine tests, symptoms, and imaging.

How long does the test take?
Timing varies by tracer and protocol. The imaging portion may take from around half an hour to longer when additional drainage images are required, and the full visit can take longer because of preparation and waiting. The department can give an estimate for the specific appointment.

Can I eat or take my medicines before the scan?
Many patients do not need to fast, but instructions vary. Continue medicines unless the treating team or imaging department says otherwise, and ask them about any medicine that affects urination or kidney function.

When will I get the results?
A nuclear medicine specialist generally interprets the images and sends a report to the referring clinician. Turnaround times vary by facility. The clinician can explain how the findings fit the reason for testing and what, if anything, should happen next.

Related

Try it: the Formula Explainer: paste any formula and see each function and reference in plain English.

More in Formulas & functions

Sources: Function behaviour and menu paths: Microsoft Support documentation for Excel. Method & sources

Spotted an error in this guide? Let us know.