Excel RV Window CH1006 Repair: Step-by-Step Guide

How-to basics · Updated November 22, 2026

To repair an Excel RV window model CH1006, you typically need to replace the gasket seal or the window latch, as these are the most common failure points. Start by removing the interior trim ring, then carefully push the window out from the inside, clean the opening, and install a new gasket or latch kit specific to the CH1006.

Understanding the Excel RV CH1006 Window

The CH1006 is a common window model used in many Excel RV trailers and fifth wheels. It is a frameless, flush-mount window with a single pane of tempered glass, a black or white gasket that seals it to the RV wall, and a simple latch mechanism. Unlike framed windows, the CH1006 relies entirely on the gasket for weatherproofing, so any crack or compression loss in that rubber seal leads to leaks, drafts, or rattling.

These windows are typically about 24 inches by 18 inches, but the exact dimensions vary slightly by year. The gasket is a continuous EPDM rubber strip that fits into a channel around the glass edge. The latch is a plastic or metal cam-style lock that pivots to press the window against the frame.

Common CH1006 Problems and Diagnosis

Before ordering parts, identify the exact issue. The most frequent problems are:

  • Water leaks – usually caused by a cracked or hardened gasket, or a gap where the gasket meets the RV wall.
  • Window rattles while driving – the latch no longer applies enough pressure, or the gasket has compressed permanently.
  • Latch won’t catch – the cam is worn, the striker plate is misaligned, or the latch screws have stripped.
  • Fogging between glass layers – for dual-pane versions, the seal between panes has failed, requiring full window replacement.
  • Cracked glass – from impact or stress; the glass itself cannot be repaired, only replaced.

To diagnose, inspect the gasket from inside and outside. Run your finger along the entire seal to feel for cracks, brittleness, or areas that have pulled away from the wall. Check the latch by opening and closing it several times; listen for a solid click and see if the window stays tight when closed.

Tools and Materials Needed for Repair

For most CH1006 repairs, you will need:

  • Phillips screwdriver (or Torx, depending on your model year)
  • Putty knife or plastic trim removal tool
  • Isopropyl alcohol and clean rags
  • New gasket (order by CH1006 part number or measure the old one)
  • New latch kit if replacing the latch
  • Butyl tape or RV sealant (for re-seating the window)
  • Safety glasses and gloves

You can order replacement parts from Excel RV dealers or online RV parts stores. Many sellers list the CH1006 gasket as a universal 1/2-inch EPDM strip, but it’s safer to match the exact cross-section. Measure the old gasket’s width and height before ordering.

Step-by-Step Repair Procedure

The repair process is similar for gasket replacement and latch replacement. Here is the general procedure:

  1. Remove the interior trim ring – Use a putty knife to gently pry off the plastic or wood trim that surrounds the window on the inside. It is held by clips or screws.
  2. Push the window out – From inside, press firmly on the glass to pop it outward. It should come free from the gasket channel. Have someone outside catch it if possible.
  3. Clean the opening – Remove old butyl tape or sealant from the RV wall and the window frame. Wipe with alcohol to ensure a clean surface.
  4. Install new gasket – If replacing the gasket, stretch it around the glass edge, making sure the channel faces outward. For latch replacement, skip to step 6.
  5. Apply sealant – Lay a bead of RV sealant or butyl tape around the window opening on the wall. Then press the window back into place, applying even pressure.
  6. Replace the latch – Screw the new latch base into the existing holes on the window frame. Align the striker plate on the wall so the cam engages properly. Adjust the striker’s position if needed.
  7. Reinstall trim – Snap or screw the interior trim ring back on.
  8. Test – Close the window, check for a tight seal, and spray water on the outside to verify no leaks.

Cost of Repair vs. Replacement

Repairing a CH1006 window is almost always cheaper than replacing the entire unit. A new gasket costs between $15 and $40, while a latch kit is around $20 to $50. If you hire a professional RV technician, labor will add $50 to $100 per hour, so a simple gasket replacement might total $100 to $200.

Full window replacement, on the other hand, costs $200 to $500 for the part alone, plus labor. Replacement is only necessary if the glass is cracked, the frame is warped, or the window is a dual-pane with failed seals. In those cases, repairing the gasket won’t solve the problem.

Safety and Maintenance Tips

When working with RV windows, always wear safety glasses and gloves, especially when removing old sealant or handling glass. Use a plastic trim tool to avoid scratching the frame. Never use a metal scraper directly on the glass.

To extend the life of your CH1006 window, regularly inspect the gasket every six months. Clean it with a mild soap and water solution; avoid petroleum-based cleaners that can dry out the rubber. Apply a UV protectant designed for RV rubber seals to prevent cracking from sun exposure.

If you notice any leak, address it promptly. Water intrusion can lead to wood rot and mold in the wall structure, which is far more expensive to repair than a gasket.

Frequently Asked Questions

Can I replace just the gasket without removing the window?
No, the gasket is installed in a channel around the glass, so the window must be removed to access it. Trying to force a new gasket in place without removal will likely tear it or leave gaps.

Where can I find the CH1006 part number?
The part number is usually stamped on the latch or on a sticker on the inside of the window frame. If not visible, measure the window and contact an Excel RV dealer with your RV’s VIN.

My window leaks only when it rains heavily – is that the gasket?
Yes, a leak under heavy rain often means the gasket has lost its compression or has a small crack. Check the top edge first, as water runs down and may enter there.

Can I use silicone caulk instead of a new gasket?
It’s not recommended. Silicone caulk doesn’t flex with the RV’s movement and will eventually crack. A proper gasket provides the necessary flexibility and sealing.

How do I know if my window is dual-pane or single-pane?
Look at the edge of the glass. Dual-pane windows have a visible spacer between two layers, and you may see a small desiccant tube. Single-pane is just one sheet of glass.

Is it safe to drive with a cracked window?
No, a cracked window can shatter while driving, especially on rough roads. Replace it before any trip.

Related

Try it: the Date Difference Calculator: days, months, years and weekdays between two dates, with the DATEDIF formulas.

More in How-to basics

Sources: Function behaviour and menu paths: Microsoft Support documentation for Excel. Method & sources

Spotted an error in this guide? Let us know.